Komatsu — ADJUSTING WORK EQUIPMENT POSTURE

. OPERATION OPERATION BANK CUTTING POSTURE (RIGHT SIDE) WARNING 3 - 158 Lower the blade t o the ground before removing the bank control lock pin. Do not remove it at any othe r position. There is d anger that it will rotate and the blade will fa ll. NOTICE to the bank cut posture, be careful not to let the blade hit any other part of the machine. When shifting to the bank cut pos ture, be careful not to let the blade hit any other part of the mac If the bank pin passes over the hol e in the lifter guide, d o not rotate the lifter any further. There is dan ger that the frame and bank pin case will c ome into contact a nd that the bank pin case will be broken. 1.

Extend the blade and drawba r fully to the right, rotate the circle and set the then lower ground. end of the blade at the side of the f ront right wheel, the blade so that it is lightly in contact with the 2. Push the b ank control lock p in switch and rem ove lock pin (1). If lock pin ( the blade li 1) is held by lifter (2) and will not co me out, operate ft cylinder to mak e it possible to re move the pin. 3.

Check that indicator pin (3) a t the rear of the lo ck pin has come out fully an the right bla to rotate lift Operate lift lock pin (1) Check that and that th d that the lock pin has been remov ed, then extend de lift cylinder an d retract the left b lade lift cylinder er (2) counterclockwise. er (2) to the desired counter mark (A ), then lock with . the protrusionof i ndicator pin (3) ha s been removed e lock pin is completely locked. NOTICE If the lock pin swi tch is kept pushed i n the pin lock direct ion while the lifter i s being rotated, there is danger th at the bushing or lifter ring will be damaged. Rotate the lifter to the spe cified counter mark, then lock the lock pin.