Komatsu — STEPS FOR TRANSPORTATION

. OPERATION TRANSPORTATION TRANSPORTATION When transporting the machine, observe all related laws and regulations, and be careful to assure safety. LOADING, UNLOADING WORK WARNING 3 - 170 STEPS FOR TRANSPORTATION As a basic rule, always transport the machine on a trailer. given in "SPECIFICATIONS (PAGE 5-2)". When selecting the trailer, see the weights and dimensions Note that the specifications for the weights and dimensions f or transportation differ according to the type of tires and type of blade. When loading or unloading the machine, run the engine at low s peed, travel at low speed, and operate slowly. level ground. install them securely at an angle of less than 15 deg.

d make sure that the slope face does not collapse. hine from slipping to the side on the ramps. ramps. machine may tip over. When loading or unloading the machine, stop the trailer on firm In addition, keep well away from the road shoulder. Use ramps of ample width, length, thickness, and strength, and When using an embankment, compact the fill soil thoroughly an Remove the mud stuck to the undercarriage to prevent the mac In addition, remove any water, snow, ice, grease, or oil from the Never change direction on the ramps. There is danger that the If it is necessary to change direction, return to the ground surfac e or the trailer platform, correct the direction, and start again.

The position of the center of gravity of the machine will change suddenly at the connection of the ramp and trailer, and there is danger of the machine losing its balance. Always drive slowl y over this point. When loading or unloading, always use ramps or a platform and carry out the operations as follows. under nd the s one of the chine n the 1. Apply the brakes on the trailer securely and insert blocks the tires to ensure that the trailer does not move. Then fix the ramps in line with the centers of the trailer a machine. Be sure that the two sides are at the same height a another. Make the angle of the ramps a maximum of 15 deg.

Set the distance between the ramps to match the center tires. 2. Set the machine in line with the ramps, then drive the ma slowly to load or unload it. 3. Load the machine correctly in the specified position o trailer. 1. Apply the brakes on the trailer securely and insert blocks REMARK When loading or unloading the machine, rotate the blade from the travel posture, then raise it fully. This makes it easier to load or unload the machine. If the ripper teeth make it difficult to load the machine, re move the ripper teeth or install them so that they face the top inside. This makes loading easier.