. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 2 , 30.0 pleats, then times the inner the outer inner and body will be CAUTION 4 - 24 5. Direc t dry compressed air (less than 0.2 MPa {2.1 k PSI} ) to the outer ele ment from inside along its direc t it from outside a long its pleats and again fro 1) R eplace the outer element if it has been clea epeatedly or used lement at the sam 2) I f the yellow displa y panel of the dust indicator enter of the scal e (5 kPa) immediately afte cleaned, replace both th lement has been uter elements, ev en when the outer element h leaned 6 times. 6.
I f small holes or thinne t is c hecked by shining a light through it after clean he e NOTICE When cleaning the elemen t, do not hit it or beat it against D o not use an element who se pleats or gasket or seal are If force is used when asse mbling, the clip or air cleaner damaged, so push it in str aight when installing it. D o not operate the machin e with the inner element remov damag e the engine. 7. Set t he cleaned outer element and install dust cup (4), then secure them with clips (3 If the inne r and outer element have been replaced, always re place O-ring (8) with a new 8. Pres s the button on du st indicator (1) to return the yellow displa y panel to its original position. 9.
Clos e the engine side cover on the right side of th e machine.