Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE REPLACE THE CUTTING EDGES, REVERSE AND REPLACE END BIT WARNING 4 - 27 CHECK ELECTRICAL INTAK Before the start of the cold seaso n (once a year), contact your Komatsu distrib utor to have the el ectrical inta ke air heater repaired or checked for di D o not raise the blade unnecessarily high. Be sure not to put any part of your body und erneath the blade wh en blocking i Replace the cutting edge before it wears to the end face of the blade. Always replace the cutting edge a nd side edge when the distance from the blad e holder is less tha n 10 mm (0 .4 in).

If the mounting surface is worn, c orrect the mounting surface before replacing the cutting edge o r side edge. 1. Lift the blade to a suitable he 2. Remove bolts and nuts (1), th edge. 3. Clean the mounting face for 4. Install a new cutting edge to 5. If the cutting portion (outside) the side edges and install the the side edges. Tightening torque of mountin 6. After several hours of runnin 1. Lift the blade to a suitable he ight and put a block underneath the blade rai l to prevent it from 2. Remove bolts and nuts (1), th en remove end bit and the cutting edge. Clean the mounting face for 4. Install a new cutting edge to 5.

If the cutting portion (outside) of the side edge is worn, reverse the side edges and install the m on the opposite side, or replace the side edges. Tightening torque of mountin 6. After several hours of runnin Replacement of cutting edge for front blade (I f equipped) Replace the cutting edge with the same procedure as that of main blade. Since front blade does not have a blade guide rail, put a block efore work. under the support of front blade b