. MAINTENANCE SERVICE PROCEDURE CHECK QUANTITY OF REFRIGERANT WARNING so please contact your Komatsu distributor to have it refilled. 4 - 29 If the refrigerant used i n the air conditioner gets in to your eyes o r on your hands, it may cause loss of sight or frostbite. Do not touch the refrigerant. Never loosen any part of the refrigerant ci Do not bring any flame close to any point where th e refrigerant g If the cooling effect i s poor, the refrigerant (g as) level may be low. If this is the case, ch eck the sight gauge of the receiver dry er under the right side of the cab.
REMARK Run the engine at i dle, and if bubbles appear in the sight glass when the air conditio neris set to cooling, the r efrigerant lev el is low, CHECK TENSION OF AIR CONDITIONER COMPRESSOR BELT If the belt is loose, it will slip and it will become impossible to carry out cooling properly. From time to time, check the belt tension. Press the belt at a point (A) midway between the drive pulley and compressor pulley and check that the deflection is 17 to 19 mm (0.67 to 0.75 in) (new belt: 15 to 16 mm (0.59 to 0.63 in)) when pushed with a finger force of approximately 98 N (10 kg).
When the belt is new, it is particularly likely to stretch at the initial stages, so it must be adjusted again after 2 to 3 days. stages, so it must b e adjusted again after 2 t o 3 days. If the belt is loose, it will slip and it will becom e impossible to carry out cooling properly . From time to time, c heck the belt tension. Pr ess the belt a t a point (A) midway betwee n the drive pulley and co mpressor pu lley and check that the deflec tion is 17 to 19 mm (0.67 to 0.75 in) (n ew belt: 15 to 16 mm (0.59 t o 0.63 in)) when pushed with a finger force of approximately 98 N Check each pulley f or damage, wear of the V -groove, an d wear of the V-belt.
Be particul arly careful to check that the V-belt does not contact the bottom of the V-groove. If the belt is stretche d and there is no allowa nce for adjus tment, o r it is cut or cracked, rep When adjusting the V-belt, do not push the c ompressor d irectly with a bar; use a wrench.