. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE in). (11) Pinion gear 4 - 62 Adjusting front and rear po 2. Lower the blade lightl loosen locknut (4), tur n back bolt (3), push open circ le guide (2), and make (Q) F = 0. (When doing this, push ope n the left and right bolts uniform 3. Adjust circle (10) fore a nd aft so that the clearance (D) between the lower flange (9) of t he circle rotator and the sliding surface of inner circumference mm (0 .8 to 0.9 4. When (Q) F = 0, tighte n locknut (4), then tighten bolt Adjusting left and right Loosen bolt (5), then lo open circle guide (6), a push open the left and 6.
The clearance betwee n the tip of the teeth of and the root of the teet h of the pinion gear should be 1 .5 to 3.0 mm (0.059 to 0.118 in) 7. When (Q) R = 0, turn b ack bolt (7) 1/4 of a turn, tighte n locknut (8), return circle guide (6) until it contacts bolt ( 7), the n tighten bolt (5). Check that it rotates 9