JCB — Service Manual Backhoe Loader

Tyre Inflation Checking the Wheel Nut Torques These instructions are for adding air to a tyre which is already inflated. If the tyre has lost all its air pressure, call in a qualified tyre mechanic. The tyre mechanic should use a tyre inflation cage and the correct equipment to do the job. On new machines, and whenever a wheel has been removed, check the wheel nut torques every two hours until they stay correct. Every day, before starting work, check that the wheel nuts are tight. ! WARNING An exploding tyre can kill, inflated tyres can explode if overheated. Do not cut or weld the rims. Use a tyre/wheel specialist for all repair work.

2-3-2-7 The correct torques are shown in the table below. Front - Nm lbf ft 680 500 1 Prepare the Wheel Before you add air to the tyre, make sure it is correctly fitted on the machine or installed in a tyre inflation cage. Rear - Nm lbf ft 680 500 2 Prepare the Equipment Use only an air supply system which includes a pressure regulator. Set the regulator no higher than 1.38 bar (20 psi) above the recommended tyre pressure. See Section F, Technical Data for recommended tyres and pressures for your machine. ! WARNING If, for whatever reason, a wheel stud is renewed, all the studs for that wheel must be changed as a set, since the remaining studs may have been damaged.

2-3-2-8 Use an air hose fitted with a self-locking air chuck and remote shut-off valve. 3 Add the Air Make sure that the air hose is correctly connected to the tyre valve. Clear other people from the area. Stand behind the tread of the tyre while adding the air. Inflate the tyre to the recommended pressure. Do not over-inflate. S089571 9803/3280 Issue 1 Section 3 Routine Maintenance Section 3 1 - 5 1 - 5 Tyres and Wheels