p 8. Insert cotter pin into wheel spindle (9). NOTICE: If hole is visible in slot but cotter pin cannot be inserted, slightly loosen or tighten castle nut to align slot with hole and insert cotter pin. If hole is not visible in slot, loosen to next available slot and install cotter pin. 9. Bend legs of cotter pin over the top of the spindle. IMPORTANT: Hub should not have noticeable movement when rocked back and forth. 10. Reassemble. 11. Tighten lug nuts to 80ft•lb (108N•m). 12. Adjust track tension. SK600 Operator’s Manual Service - 73 Procedures Idler Roller Bearings Check every 300 hours. Adjust as needed. Check 1. Lift machine off ground. 2. Release track tension.
See “Track Tension” on page 76. 3. Check for movement of each hub (shown) when rocked back and forth. If hub has noticeable movement, adjust idler roller bearing. 4. Tension track. t51om027w.eps Adjust 7 1. Release track tension. See “Track Tension” on 1 page 76. 2. Remove bolts (1, drive roller) or flange lock 9 nuts (8, idler roller) and lug nuts (3) to 6 remove dust cap retainer (2). 5 3. Remove dust cap (4). 4 4. Remove cotter pin (6). 3 5. Ensure bearings are properly seated by 2 tightening castle nut (5) to 30-40ft•lb (40.7- 54.2N•m) while turning the hub (7). NOTICE: Do not move hub after this 8 step is completed. t51om029w.eps 6. Loosen castle nut. 7. Hand-tighten castle nut.
Idler Roller Bearings Check every 300 hours. Adjust as needed. Check 1. Lift machine off ground. 2. Release track tension. See “Track Tension” on page 76. 3. Check for movement of each hub (shown) when rocked back and forth. If hub has noticeable movement, adjust idler roller bearing. 4. Tension track. t51om027w.eps Adjust 1. Release track tension. See “Track Tension” on 1 page 76. 2. Remove bolts (1, drive roller) or flange lock nuts (8, idler roller) and lug nuts (3) to remove dust cap retainer (2). 3. Remove dust cap (4). 4 4. Remove cotter pin (6). 3 5. Ensure bearings are properly seated by 2 tightening castle nut (5) to 30-40ft•lb (40.7- 54.2N•m) while turning the hub (7). NOTICE:
Do not move hub after this 8 step is completed. t51om029w.eps 6. Loosen castle nut. 7. Hand-tighten castle nut. 7 9 6 5 1om027w.eps