Caterpillar — Engine Diagnostics

34 Operation Section Engine Diagnostics Engine Diagnostics The “DIAGNOSTIC” lamp blinks on and off at five second intervals. i01463253 Diagnostic Lamp When the ignition key is in the ON position, the lamp is checked for proper operation. If there are any active codes except for Code 34, the codes are displayed at this time. SMCS Code: 1000; 1900; 1901; 1902; 7451 The “DIAGNOSTIC” lamp is used to indicate the existence of an active fault by flashing codes. Note: The “DIAGNOSTIC” lamp will illuminate for five seconds. The lamp will stay on if there is an active diagnostic code. When the ignition switch is first turned on, the “DIAGNOSTIC” lamp will go through the following procedure: 2.

The Active Diagnostic codes will always be flashed. There is no toggle switch that will shut off the lamp. The “DIAGNOSTIC” lamp will come on and the “DIAGNOSTIC” lamp will remain on for five seconds. This checks the operation of the lamp. 3. The “DIAGNOSTIC” lamp will flash in order to indicate a two-digit code. The sequence of flashes represents the system diagnostic message. Each digit of the two-digit code is determined by counting the number of flashes. The lamp flashes at a rate of two times per second. The lamp will pause for one second between digits. The lamp will pause for two seconds between codes. The “DIAGNOSTIC” lamp will turn off.

The “DIAGNOSTIC” lamp will come on again and the “DIAGNOSTIC” lamp will flash codes for any active diagnostic codes. Not all diagnostic codes have a unique flash code. The “DIAGNOSTIC” lamp will turn off for five seconds. Table 8 indicates the potential effect on the engine performance with active flash codes. Table 8 also forms a list of Electronic diagnostic codes and descriptions. The “DIAGNOSTIC” lamp repeats all active diagnostic codes. A fault diagnostic code will remain active until the problem is repaired. The electronic control module will continue flashing the flash code at five second intervals until the problem is repaired. i01474158 Diagnostic Flash Code Retrieval SMCS Code:

1000; 1900; 1901; 1902 “Diagnostic” Lamp Use the “DIAGNOSTIC” Lamp or Caterpillar ET in order to determine the diagnostic flash code. Use the following procedure to retrieve the diagnostic codes if the engine is equipped with a “DIAGNOSTIC” lamp: 1. Turn the ignition key to the ON position. The engine does not need to be started in order to view codes. The engine does not need to be running while the ignition switch is in the ON position.