36 Operation Section Engine Diagnostics (Table 8, contd) (1) Shut down the Engine: Operate the engine cautiously. Get immediate service. Severe engine damage may result. (2) The operator should go to the nearest location for service. (3) The operator should investigate the problem at a convenient time. (4) The Diagnostic Flash Codes reduce the effectiveness of the Engine Monitoring feature. (5) These Diagnostic Flash Codes may affect the system only under specific environmental conditions such as engine start-up at cold temperatures, etc. i01463504 Fault Logging SMCS Code: 1000; 1900; 1901; 1902 The system provides the capability of Fault Logging.
When the Electronic Control Module (ECM) generates an active diagnostic code, the code will be logged in the memory of the ECM. The codes that have been logged in the memory of the ECM can be retrieved with Caterpillar electronic service tools. The codes that have been logged can be cleared with Caterpillar electronic service tools. The codes that have been logged in the memory of the ECM will be automatically cleared from the memory after 100 hours. The following faults can not be cleared from the memory of the ECM without using a factory password: overspeed, low engine oil pressure, and high engine coolant temperature.
Diagnostic Flash Codes for C-9 Industrial Engine Diagnostic Flash Code Effect On Engine Performance Suggested Action by the Operator Engine Misfire Low Power Reduced Engine Speed Engine Shut Down Shut down the Engine(1) Service(2) Schedule Service for the Engine.(3) 64 Even for High Inlet Manifold Air Temperature X X X 65 Event for High Fuel Temperature X X X 72 Fault of Cylinder 1 or Cylinder 2 X X X 73 Fault of Cylinder 3 or Cylinder 4 X X X 74 Fault of Cylinder 5 or Cylinder 6 X X X