Caterpillar — Engine Starting

40 Operation Section Engine Starting i01512354 Starting the Engine All of the guards must be put in place. Check for damaged guards or for missing guards. Repair any damaged guards. Replace damaged guards and/or missing guards. SMCS Code: 1000; 1450 Disconnect any battery chargers that are not protected against the high current drain that is created when the electric starting motor (if equipped) is engaged. Check electrical cables and check the battery for poor connections and for corrosion. Engine exhaust contains products of combustion which may be harmful to your health.

Always start and operate the engine in a well ventilated area and, if in an enclosed area, vent the exhaust to the outside. Reset all of the shutoffs or alarm components. Check the engine lubrication oil level. Maintain the oil level between the mark and the mark on the oil level gauge. Initial Inspection Perform the required daily maintenance and other periodic maintenance before you start the engine. Inspect the engine compartment. This inspection can help prevent major repairs at a later date. Refer to the Operation and Maintenance Manual, “Walk-Around Inspection” topic (Maintenance Section) for more information. Check the coolant level.

Observe the coolant level in the coolant recovery tank (if equipped). Maintain the coolant level to the mark on the coolant recovery tank. If the engine is not equipped with a coolant recovery tank maintain the coolant level within 13 mm (.5 inch) of the bottom of the filler pipe. If the engine is equipped with a sight glass, maintain the coolant level in the sight glass. For the maximum service life of the engine, make a thorough inspection before you start the engine. Look for the following items: oil leaks, coolant leaks, loose bolts, and trash buildup. Remove trash buildup and arrange for repairs, as needed. Observe the air cleaner service indicator (if equipped).

Service the air cleaner when the yellow diaphragm enters the red zone, or when the red piston locks in the visible position. Inspect the cooling system hoses for cracks and for loose clamps. Inspect the alternator and accessory drive belts for cracks, breaks, and other damage. Ensure that any driven equipment has been disengaged. Remove any electrical loads. Inspect the wiring for loose connections and for worn wires or frayed wires. Cold Weather Starting Starting the engine and operation in cold weather is dependent on the type of fuel that is used, the oil viscosity, and other optional starting aids.

For more information, refer to the Operation and Maintenance Manual, “Cold Weather Operation” topic (Operation Section). Check the fuel supply. Drain water from the water separator (if equipped). Open the fuel supply valve. NOTICE All valves in the fuel return line must be open before and during engine operation to help prevent high fuel pressure. High fuel pressure may cause filter housing failure or other damage. Air Inlet Heater Do not start the engine or do not move any of the controls if there is a NOT OPERATE” warning tag or similar warning tag attached to the start switch or to the controls. DO NOT USE ETHER (starting fluids) unless specifically instructed to do so.

If the engine is equipped with an Air Inlet Heater (electrically or fuel ignited manifold heater), DO NOT use ether (starting fluids) at any time. The use could result in engine damage and/or personal injury. Ensure that the areas around the rotating parts are clear. Note: There will be an indicator lamp on the control panel that is marked “AIR INLET HEATER”.