. OPERATION EXPLANATION OF COMPONENTS PRECAUTION WHEN USING AIR CONDITIONER refrigerant 3 - 63 PRECAUTION WHEN USING COOLING OPERAT ION If you smok e when using the air conditioner, your eyes may start to itch or burn. Ventilate the cab ever so often to remove t he smoke. the air conditioner for a long period of time, carry out ventilation process at least once every hour. When using the air conditioner for a long pe riod of time, carry out ventilation pro cess at least once every When using th e air conditioner, it is recommen ded for health reasons, that it should only feel slightly cooler ( 5 or 6 °C (9 or 10.8° F) lower than the outside temper ature) when you enter the cab. level.
Therefore, adj ust the temperature to a suitable SET SO THAT COLD AIR DOES NOT DIRECTLY BLOW ONTO THE GLAS S SURFACE If the vents ( left and right) in the middle of the dashboard are turned so that cold ai r plays directly on the cab door glass, mois particularly If this happe on the surfa ture may condense on the outs in high temperatures.) ide of the cab door glass and reduce the visibility.
(This occurs ccurs ns, close the louvers of the vent and change the direction to prevent t he cold air from playing di rectly ce of the glas INSPECTION DURING OFF-SEASON Even during th e off-season, run the compresso r at low speed for several minutes o nce a week to prevent th e loss of the oil film at the lubricated parts of the compr essor. (Run the engine at low speed and set the temperature c ontrol lever at the ce ntral position.) REMARK When the amb ient temperature is low, if the co mpressor is suddenly run at high sp eed, it may cause failure of the compressor.
N ote that the system is set so tha t the compressor will not run when th e cooler switch is turned on, if the ambient te mperature is less than 2 to 6.5°C (35.6 to 43.7°F). PROCEDURE FOR REPLACING RECEIV ER Replace the re ceiver once every two years. After replacing the receiver, add compressor oil . Turn the receiver at an angle and m easure the oil remaining i nside the receiver, th en add the same amount of oil ( Denso Oil 6) to fill the receiver. REMARK The replac ement interval may become shor ter depending on the conditions duri If the recei ver is used when the moisture a bsorption limit of the desiccant has b compressor to break down.
circuit may become blocked and cause the PRECAUTIONS WHEN REPLACING RECEIVER utes with the blind cover removed, the moisture in the air will be If the receiv er is left for more than 15 min absorbed, a evacuate th nd this will reduce the life of the desiccant. If you remove the blind co ver, connect the piping qu ickly, e system and fill with refrigerant. rigerant circuit, release it gradually from the low pressure side to When remo ving the refrigerant from the ref rom flowing out. prevent oil f CHECK COMPRESSOR BELT TENSION AND REFRIGERANT (GAS) LEV If the compres sor belt is loose, or the refrigera nt level is low, cooling is not carried For details, se e "WHEN REQUIRED (PAGE 4- 20)".