Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION CHECK BEFORE STARTING CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL WARNING after the engine is stopped and may cause serious burns. Wait for the oil is above the H mark, remove cover (1) at the Loosen drain plug (P), drain the excess oil, then check the oil is correct, tighten the oil filler cap securely and 3 - 68 Always check the items in this se ction before s tarting the en gine Parts and oil are at high temperature immediately temperature to go d own before performing this oper 1. Open the eng ine side cover o n the left sid e of the chass 2. Remove dips tick (G) and wip e the oil off w ith a cloth. 3.

Fully insert di pstick (G) into fil ler pipe (F), t hen remove it 4. The oil level s hould be betwe en the H and L marks on di pstick ( I f G). f the oil level is below the L mark, add engine oil through oil iller (F). 5. I bottom of the Loosen drain evel again. f the oil level close the eng REMARK is at an angle, reposition it to level before checking. If the machine is at an angle, r eposition it to level before When checkin g the oil level aft er the engine has been op erated, allow the engine to co ol for 15 minutes before checking.