. OPERATION OPERATION FASTENING AND REMOVING SEAT BELT (If equipped) WARNING 3 - 77 Before fastening the seat belt, che ck that there is no problem in the securing brackets or belt. If t here is any wear or damage, replace. Even if there appears to be no pro blem in the seat belt, replace the seat bel t once every 3 years. The date of manufacture is woven on the reverse side of the b elt. ore operating the machine. rating the machine. r half of the belt twisted. Adjust and fasten the seat belt bef Always use the seat belt when ope D o not use the seat belt with eithe Check that the bolts of the clamp securing the belt to the chassis are not loose.
Tighten t The tightening torque for the mou nting bolt is 24.5 ± 4.9 N·m (2.5 ± 0. 5 kgf·m, 18.1 ± 3.6 If th e belt surface is scratched or frayed or if the fittings are broken or deformed, replace FASTENING AND REMOVING SEAT B ELT ion, adjust tether belt (1). Tense 1. t 2. 3. I t 1. After adjusting the seat posit he tether belt and install it w hen there is no one sitting on the seat. Sit on the seat and hold to ngue (4) connected to wind-in 2. mechanism (2) and pull out th e belt slowly so that the belt will cover your abdomen sufficien tly. ) until it clicks. The belt is pulled 3. I nsert tongue (4) in buckle (3 back into wind-in mechanis abdomen.
The belt is locked m (2) until it is fitted to your under this condition and cannot be extended anymore. Fit th wisting it. e belt to your abdomen without REMARK If th e belt is locked before the ton gue is inserted in the buckle, let it nism, then repeat the above 4. Pull the belt to check that it is 5. When removing the belt, pres The belt will automatically be