Komatsu — IF BATTERY IS DISCHARGED

. OPERATION TROUBLESHOOTING IF BATTERY IS DISCHARGED WARNING battery, stop the engine and turn the wear protective goggles and rubber 3 - 128 It is dangerous to charge a battery sure that it is dismounted before c When checking or handling the b starting switch key to the OFF pos The battery generates hydrogen g Do not bring lighted cigarettes nea cause sparks. Battery electrolyte is dilute sulfuri and skin. If it gets on your clothes off with a large amount of water. If fresh water and consult a doctor. When handling batteries, always gloves. When removing the battery, first d (normally the negative (-) terminal) (+) terminal first.

If a tool touches the positive term that it will cause a spark, so be ex If the terminals are loose, there is d generate sparks that will cause an When removing or installing the te (+) terminal and which is the nega REMOVE AND INSTALL BAT TERY 1. Open the battery cover. 2. Before removing battery, rem touches between the positive nuts of the terminal and remo 3. After installing the battery, fix Tightening torque: 1.47 to 1.9 4. When installing the battery, c Insert the hole of the termina Tightening torque: 11.8 to 19 1. Open the battery cover. 2. Before removing battery, rem ove the ground cable (normally connected to t he negetive (-) ter minal).

If an y tool terminal and the chassis, there is danger of s parks being gener ated. Loose n the ve the wires from the battery. it with the battery hold down. 6 N·m (0.15 to 0.2 kgf·m, 1.1 to 1.4 lbft) onnect the ground cable last. l on the battery and tighten the nut. .6 N·m (1.2 to 2.0 kgf·m, 8.7 to 14.5 lbft) 3. After installing the battery, fix 6 N·m (0.15 to 0.2 kgf·m, 1.1 to 1.4 4. When installing the battery, c l on the battery and tighten the nut .6 N·m (1.2 to 2.0 kgf·m, 8.7 to 14.5