Komatsu — CLEAN INSIDE OF COOLING SYSTEM

. MAINTENANCE SERVICE PROCEDURE WARNING 4 - 24 When deciding the ratio of antifree ze to water, check the lowest temperature in the past, and decide from the mixing table given below. d temperature about 10°C (18°F) lower when deciding the mixing ratio. ambient temperature, but it should always be a minimum of 30% by volume t x 100). It is actually better to estimate an d temperature about 10°C (18°F) lowe r when deciding th The mixing ratio depends on the (antifreeze/total amount of coolan The freezing temperature of undil uted antifreeze is -15°C (5°F). Do not store undiluted anti freeze at a temperature o f below -15°C (5°F). e Mixing rate of water and antifreez °C Min.

atmospheric temperature °F Above -10 -15 -20 -25 -3 Above 14 5 -4 -13 -2 Liters Amount of antifreeze US gal 17.4 20.9 23.8 26.7 29. 4.60 5.52 6.29 7.05 7.6 Liters Amount of water US gal 40.6 37.1 34.2 31.3 29. 10.72 9.80 9.04 8.27 7.6 Ratio % 30 36 41 46 50 Antifreeze is flammable, so keep it aw ay from flame. Antifreeze is toxic. When removing th e drain plug, be careful not to get wat er containing antifreeze on you. If it gets in your e yes, flush your eyes with large amount of fresh water and see a doctor at once. Use antifreeze and appropriate wa ter for diluting (for details, see "COOLANT AND WATER FOR DILUTION (PAGE 4-6)") eze density gauge to control the mixing proportions.

ity is larger than the specified coolant volume to catch drained coolant. ze coolant and water. valves of the corrosion resistor. ntil it hits the stopper and by so essure. it hits the next stopper, while e radiator cap (1) until it hits the e antifreeze solution under drain he radiator and drain valve (3) on ove drain valve (3) to drain the olution, close drain valve (2), (3), r the radiator is filled with water, w idling speed. After the water °C (194°F), run the engine for in valve (2), (3) to drain the water. the cooling system with cleaning agent. the instructions for the cleaning agent.

We recommend use of an antifre eze density gauge to control the mixin Prepare a container whose capac ity is larger than the specified coolant volume to catch dr Prepare a hose to supply antifree 1. Stop the engine and tighten 2 2. Turn radiator cap (1) slowly u doing, relieving the internal pr 3. Turn radiator cap (1) until depressing it. Keep turning th last stopper. 4. Place a container to receive th valve (2) on the underside of t the side of the cylinder block. Open drain valve (2) and rem antifreeze solution. 5. After draining the antifreeze s then fill with clean water. Afte start and run the engine at lo temperature rises above 90 about 10 minutes. 6. Stop the engine and open dra 7.

After draining the water, clean For the cleaning method, see 1. Stop the engine and tighten 2 valves of the corrosion resistor. 2. Turn radiator cap (1) slowly u 6. Stop the engine and open dra in valve (2), (3) to drain the wate 7. After draining the water, clean the cooling system with cleanin the instructions for the cleaning agen