Komatsu — ADJUST IDLER CLEARANCE

. MAINTENANCE SERVICE PROCEDURE CHECK IDLER OIL LEVEL, ADD OIL WARNING INSPECTION 1. Remove bolt (1), then remove guide plate (2) and shim (3). 2. Loosen plug (4) slowly. If oil oozes through the threads at this 3. If any oil does quantity of oil is insufficient. In this case, ask your Komatsu distributor for repair. 4. Install guide plate (2) and shim (3) with bolt (1). 4 - 37 If the oil level in the idle r is low, new oil must be added, an d the machine body must be inclined in this case. Since this work is dangerous, ask your Ko matsu distributor. If the oil level in the id ler is low, noise will be genera ted and there will be seizure, so che ck the oil level and add oi as follows.

REMARK When removing shim (3) keep it in a safe place and be careful not to lose it. of oil is sufficient. Tighten plug (4). removed, the REMARK When installing guid e plate (2), install the same number and as removed in Step 1. thickness of shim (3) The optimum cleara made at the same tim nce may be obtained, if the e. For details of adjusting the sh adjustment is im thickness, see "ADJUST IDLER CLEARANCE (PAGE 4-37)". ADJUST IDLER CL EARANCE rced to move forward and backward by an external force guide plates will be worn out.

Since the idlers are fo rced to move forward and bac kward by an external force guide pl ates will be worn ou Wear of these plates will cause the vibration of idlers from side to side or inclination of th e idlers, and runnin g off of track links from the id lers or unevenly worn idler and links may result. g procedure. Therefore, adjust the idlers according to the followin g procedure. ADJUSTMENT 1. Move the machin place, then meas guide plate (at fo 2. If the clearance A and pull out the s to 1.0 mm (0.02 t Thickness of one e by 1 to 2 m (3 ft 3 in to 6 ft 7 in) on a leve ure clearance A between the tr ack frame and ur places of both sides, inside, and outside).

exceeds 4.0 mm (0.16 in), lo osen bolt (1), him to adjust the clearance at o ne end to 0.5 o 0.04 in). shim is 1.0 mm (0.04 in).