. ATTACHMENTS, OPTIONS HANDLING HYDRAULIC RIPPER OPERATION CHECK BEFORE STARTING ENGINE, ADJUST WALK-AROUND CHECK ADJUSTING POSTURE OF WORK EQUIPMENT 6 - 5 1. Check for wear of the p oint at t he ti p of t he shank, ch eck the mounting condition, and c heck for damage to the rivets. If a ny abnormalit y is found, r eplac e or r PRECAUTIONS WHEN OPERATIN Travel in lo w speed and lower t he ri digging de pth is reached , move the contro l leve r to th e HOLD position. Do not dig the shank in d eep when s tartin g digging op erations During rip ping operation s, neve r tur n the machine s uddenly or travel in suddenly o r traveling in r everse , rais e the shank from the ground surface.
When carr diggi shank the shanks. When start ing to travel up a stee p slo pe or when r eachi ng the bottom o f the slope , the poin t may touch the gr ound. On hard gr ound, there is danger of th e poi nt breaking if it touches the ground, so raise the shank to the maximum height. ADJUSTMENT OF DIGGING DEPTH There are mo unting holes f or the p in in the s hank. Selec t the mounting hole to match the d igging depth. Pin hole position Use Max. digging depth W (A) d hen there is special need to ig deeply 595mm (23.4 in) (B) N ormal 485mm (21.9 in) (C) W hen not using ripper -