. OPERATION EXPLANATION OF COMPONENTS METHOD OF USING PM CLINIC AUXILIARY MODE CAUTION or setting the transmission to the travel position for carrying out measurements, check * 0.0 MPa is shown as the value for hydraulic oil pressure of the work equipment, as this machine is not equipped with a sensor for this purpose. REMARK Items such as the engine speed fluctuate and are difficult to see during the measurement. In such cases, operate the buzzer cancel switch to U . This makes it possible to hold the display of the value. To cancel this mode, operate the buzzer cancel switch again to U . To return to the maintenance mode, operate the buzzer cancel switch to t .
3 - 28 Whe moving quipme carefully that the situation is safe. The PM clinic au xiliary mode display s the engine speed o r hydraulic pressure on display panel B (multi-information). Display panel B displays the item the top line measured value on the bottom line ( The display item s consist of th e four items i n the table b elow. The items can b e selected by operating the information switch ( >). Display Item Measured value 01-ENG.SPEED Engine speed Speed (rpm) 02-BOOST PRESSURE Boost pressure Pressure (kPa) 03-HYD.PUMP PRES Hydraulic oil pressure Pressure (MPa)* 04-BATTERY VOLT Battery voltage Voltage (V)