Aegis LH630-775 — Section 10 - Inspection and Reconditioning

Section 10 Inspection and Reconditioning Valve Guides If a valve guide is worn beyond specifications, it will not guide the valve in a straight line. This may result in burnt valve faces or seats, loss of compression, and excessive oil consumption. Valve Seat Cutter To check valve guide-to-valve stem clearance, thoroughly clean the valve guide and, using a split- ball gauge, measure the inside diameter. Then, using an outside micrometer, measure the diameter of the valve stem at several points on the stem where it moves in the valve guide. Use the largest stem diameter to calculate the clearance.

If the intake clearance exceeds 0.038/0.076 mm (0.0015/0.003 in.) or the exhaust clearance exceeds 0.050/0.088 mm (0.0020/0.0035 in.) , determine whether the valve stem or guide is responsible for the excessive clearance. Pilot Figure 10-7. Typical Valve Seat Cutter. Lapping Valves Reground or new valves must be lapped in, to provide fit. Use a hand valve grinder with suction cup for final lapping. Lightly coat valve face with “fine” grade of grinding compound, then rotate valve on seat with grinder. Continue grinding until smooth surface is obtained on seat and on valve face. Thoroughly clean cylinder head in soap and hot water to remove all traces of grinding compound.

After drying cylinder head, apply a light coating of engine oil to the seats to prevent rusting. Maximum (I.D.) wear on the intake valve guide is 7.134 mm (0.2809 in.) while 7.159 mm (0.2819 in.) is the maximum allowed on the exhaust guide. The guides are not removable but can be reamed 0.25 mm (0.010 in.) oversize. Valves with 0.25 mm oversize stems must then be used. If the guides are within limits but the valve stems are worn beyond limits, replace with new valves. Valve Seat Inserts Hardened steel alloy intake and exhaust valve seat inserts are press fitted into the cylinder head.

The inserts are not replaceable on the engines but can be reconditioned if not too badly pitted or distorted. If cracked or badly warped, the cylinder head should be replaced. Intake Valve Stem Seal These engines use valve stem seals on the intake valves. Always use a new seal when valves are removed from cylinder head. The seals should also be replaced if deteriorated or damaged in any way. Never reuse an old seal. Recondition the valve seat inserts following the instructions provided with the valve seat cutter being used. A typical cutter is shown in Figure 10-7. The final cut should be made with an 89° cutter as specified for the valve seat angle in Figure 10-6.

With the proper 45° valve face angle as specified in Figure 10-6 and the valve seat cut properly (44.5° as measured from centerline when cut 89°) this would result in the desired 0.5° (1.0° full cut) interference angle where the maximum pressure occurs on the outside diameters of valve face and seat. 10.8