Aegis LH630-775 — Section 10 - Inspection and Reconditioning

Section 10 Inspection and Reconditioning Replacement pistons are available in STD bore size, 0.08 mm (0.003 in.), 0.25 mm (0.010 in.), and 0.50 mm (0.20 in.) oversizes. Replacement pistons include new piston ring sets and new piston pins. The ring sets are also available separately. Always use new piston rings when installing pistons. Never reuse old rings. Some important points to remember when servicing piston rings: 1. The cylinder bore must be deglazed before service ring sets are used. Figure 10-10. Measuring Piston Ring Side Clearance. 2.

If the cylinder bore does not need reboring and if the old piston is within wear limits and free of score or scuff marks, the old piston may be reused. Install Piston Rings To install piston rings, proceed as follows: 3. Remove old rings and clean up grooves. Never reuse old rings. NOTE: Rings must be installed correctly. Ring installation instructions are usually included with new ring sets. Follow instructions carefully. Use a piston ring expander to install rings (see Figure 10-11). Install the bottom (oil control) ring first and the top compression ring last. Refer to Figure 10-12. 4.

Before installing the new rings on the piston, place the top two rings, each in turn, in its running area in cylinder bore and check end gap (see Figure 10-9) against the specifications listed in Section 1. Figure 10-9. Measuring Piston Ring End Gap. Figure 10-11. Installing Piston Rings With Expander. 5. After installing the new top and middle compression rings on piston, check piston-to- ring side clearance. Compare findings against the specifications listed below. If clearance is greater than specified, a new piston must be used. Refer to Figure 10-10. 10.10