Aegis LH630-775 — Section 5B - EFI Fuel System

Section 5B EFI Fuel System 3. Insert a nail into the hole in the top of the cross shaft. Using light pressure, rotate the governor shaft counterclockwise as far as it will turn, then torque the hex nut on the clamping screw to 6.8 N·m (60 in. lb. ). See Figure 5B-34. Make sure that the governor arm has not twisted up or down after the nut has been tightened. Troubleshooting Guide Engine starts hard or fails to start when cold 1. Fuel pump not running 2. Engine temp sensor faulty 3. Incorrect fuel pressure 4. TPS faulty 5. TPS offset incorrect 6. Old/stale fuel 7. Low system voltage 8. Speed sensor loose or faulty 9. Faulty injectors 10. Faulty coils 11.

Faulty spark plugs Engine starts hard or fails to start when hot 1. Fuel pressure low 2. Fuel pump not running 3. Engine temp sensor faulty 4. Insufficient fuel delivery 5. TPS faulty 6. TPS offset incorrect 7. Speed sensor loose or faulty 8. Faulty injectors 9. Faulty spark plugs Figure 5B-34. Adjusting Governor Shaft. 4. Verify that the governor has been set correctly. With the linkage still retained in the “Full Throttle” position (Step 2), unsnap the bushing clip, separate the linkage from the bushing, and remove the bushing from the lever. Follow Steps 3 and 4 in ‘‘Checking the Initial Adjustment’’. Engine misses, hesitates, or stalls under load 1.

Fuel injector(s), fuel filter, fuel line, or fuel pick-up dirty/restricted 2. Dirty air cleaner 3. Insufficient fuel pressure or fuel delivery 4. Vacuum (intake air) leak 5. Improper governor setting, adjustment or operation 6. Speed sensor malfunction 7. TPS faulty, mounting problem or "TPS Initialization Procedure" incorrect 8. Bad coil(s), spark plug(s), or wires 5. Reconnect the dampening spring into its governor lever hole from the bottom. Reinstall the bushing and reattach the throttle linkage. See Figure 5B-30. Reattach the governor spring in the marked hole. 6. Start the engine and allow it to fully warm up and establish closed loop operation (approximately 5-10 min.).

Check the speed settings and adjust as necessary, first the low idle speed, and then the high speed setting. Low Power 1. Faulty/malfunctioning ignition system 2. Dirty air filter 3. Insufficient fuel delivery 4. Improper governor adjustment 5. Plugged/restricted exhaust 6. One injector not working 7. Basic engine problem exists 8. TPS faulty or mounting exists 9. Throttle plates in throttle body/intake manifold not fully opening to WOT stop (if so equipped) Troubleshooting General When troubleshooting a problem on an engine with EFI, basic engine operating problems must be eliminated first before faulting the EFI system components.

What appears to be an EFI problem could be something as simple as a fuel tank with debris in the bottom or a plugged vent. Be sure the engine is in good mechanical operating condition and all other systems are functional before attempting to troubleshoot the EFI system. 5B.22