Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Fuel 47 the fuel heater/water separator by opening the drain valve. 1 3. Remove the filter element and collection bowl together, by turning the filter element off of the mounting head. 4. Remove the filter element from the collection bowl by turning the collection bowl; then discard the filter element. 2 5. Remove and discard the bowl O-ring; then clean the bowl of debris using diesel fuel only. Clean the bowl O-ring seat with a shop cloth. 6. Lubricate the new bowl O-ring with clean diesel fuel or motor oil; then seat it into the collection bowl. 3 4 7. Attach the collection bowl to a new filter element, hand-tight. Do not use tools. 6 5 8.

Lubricate the new filter element gasket with clean diesel fuel or motor oil. 02/07/97 f470276 9. Spin the filter and bowl assembly onto the mounting head until the gasket contacts the head base; then turn it an additional 1/3 to 3/4 of a turn. 1. Filter Vent 2. Filter Element 3. Filter Stud Seal 4. Filter Stud 5. Davco Unit Body 6. Fuel Port 10. Connect the water sensor probe connector and bowl heater connector, if equipped. Fig. 8, Davco 321 11. Remove the priming plug located at the top of the fuel/water separator and manually fill the fuel/water separator with clean diesel fuel.

Install and tighten the priming plug open flame or intense heat could start a fire, pos- sibly resulting in personal injury or property dam- age. When working on a fuel system, have a fire extinguisher within easy reach. 1. Place a suitable container under the fuel heater/water separator. Open the filter vent using a 1-1/8 wrench; then drain the fuel from the fuel heater/water separator by opening the drain valve. 12. Start the engine and check for fuel and coolant leaks. Repair all leaks with the engine OFF. Davco Fuel Heater/Water Separator Filter Element Replacement Davco 321 2. Close the drain valve. 3.

Remove the filter element by spinning the filter element off of the fuel heater/water separator body. The only maintenance necessary on Davco 321 fuel separators is to replace the filter element. See Fig. 8 . 4. Remove the filter stud seal; then clean the top of the unit body. 5. Add fuel to the fuel heater/water separator hous- ing until it reaches the top of the fuel port. WARNING Diesel fuel is flammable and can ignite if exposed to an open flame, intense heat, or other ignition source. Do not drain fuel near, or expose fuel vapor to open flame or intense heat. Exposure to 6. Install a new filter stud seal. 7. Coat the filter gasket with clean oil.

Spin the filter element onto the unit housing unit it contacts the gasket; then turn it 1/2 to 3/4 turns more. Do not use a filter wrench to tighten the filter Heavy-Duty Trucks Maintenance Manual, October 1997 47/7