Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Cab 60 60–01 Cab-Tilt System Checking, FLA/FLB 60–02 Cab-Suspension Spring Center-Bolt Torque Checking, FLC Before checking the fluid level in the tilt pump reser- voir, the cab must be in the operating position, with the cab latches locked. Let it remain in this position for at least five minutes before checking the reser- voir. The reservoir is full when the fluid is at the level of the fill hole. See Fig. 1 . Check the torque of the cab-suspension spring center-bolt locknut. The locknut must be tightened 85 lbf·ft (115 N·m). 60–03 Cab Latch Checking, FLA/FLB If the fluid level is low, check all fittings and lines for leaks.

If any fittings are loose, tighten them finger- tight, then tighten with a wrench until there is firm resistance; tighten one-sixth turn more. Replace any damaged or worn fittings or lines before adding fluid. Then bleed any air from the system; see Group 60 of the Heavy-Duty Trucks Service Manual for instruc- tions. Add tilt system hydraulic fluid (MIL-H-5606) to bring the level up to the fill hole. Approved tilt pump fluids are: Texaco 1537 Aircraft Hydraulic Oil 15, Union Arctic Low Pour (-65) Hydraulic Fluid 04617, and Filmite 530 Hydraulic Oil. Check the latch for correct operation. For cab latch adjustment, see Group 60 of the Heavy-Duty Trucks Service Manual. 1. Fill Plug (behind lever) Fig.

1, Power-Packer Tilt Pump A "spongy" feel in the operation of the pump indi- cates that air is present in the hydraulic cab-tilt sys- tem. Bleed the air from the system; see Group 60 of the Heavy-Duty Trucks Service Manual for instruc- tions. Check for wear of the clevis pin and cotter pin on both tilt cylinders. Check the tilt pump mounting bolts for tightness; see Group 00 of this manual for torque values for lubricated or plated-thread fasteners. Heavy-Duty Trucks Maintenance Manual, January 1997 60/1 10/11/93 1 f31