Heater and Air Conditioner 83 83–01 Air Conditioner Inspecting WARNING Wear eye protection, gloves, and protective cloth- ing when working on the air conditioning system. Leaking refrigerant from a damaged hose or line could cause blindness or serious skin burns. Preliminary Checks 1. Park the vehicle on a level surface, apply the parking brakes, and chock the tires. 08/25/94 f830641 Fig. 1, Drive Plate Clearance Inspection 2. Check the appearance of the air conditioner compressor pulley assembly. If the friction sur- face of the pulley shows signs of excessive grooving due to belt slippage, replace both the pulley and the drive plate.
Visually inspect the refrigerant compressor drive belt for damage, and check that the belt is set at the proper ten- sion. Also check the tightness of the compressor mounting fasteners. For instructions and torque values, see Group 01 of the Heavy-Duty Trucks Service Manual. 6. Check the overall condition of the air conditioning hoses. Look for cracks, cuts, and abrasions on the hoses. Replace damaged hoses, see Group 83 of the Heavy-Duty Trucks Service Manual for replacement instructions. Also, check for loose fittings on all air conditioning components. 7. Check for a build-up of road debris on the con- denser fins.
See Group 83 of the Heavy-Duty Trucks Service Manual for cleaning instructions. Refrigerant Checking 3. Inspect the drive plate. If the friction surface of the drive plate shows visible signs of damage due to excessive heat, replace the drive plate and pulley assembly. See Group 83 of the Heavy-Duty Trucks Service Manual for removal and installation procedures. Find the moisture indicator sight glass on the receiver-drier and check the color of the moisture indicator. See Fig. 2 . If the indicator is a deep cobalt blue, the refrigerant charge is dry. 4. On a Sanden refrigerant compressor, use a feeler gauge to check that the drive plate clutch clearance is 0.016 to 0.03 inch (0.4 to 0.8 mm).
See Fig. 1 . If the drive plate clutch requires ad- justment, see Group 83 of the Heavy-Duty Trucks Service Manual. If the indicator is not blue, the system is contami- nated with water. If the system is contaminated, the refrigerant must be recovered and the receiver-drier must be replaced. See Group 83 of the Heavy-Duty Trucks Service Manual for instructions. On a Climate Control refrigerant compressor, place a feeler gauge between the air conditioner compressor clutch and the pulley, to check the compressor clutch clearance. Drive plate to pul- ley clearance is 0.02 to 0.03 inch (0.6 to 0.8 mm). If the clearance is not correct, see Group 83 of the Heavy-Duty Trucks Service Manual. 5.
Inspect the compressor clutch coil wire. Check that the connector is not damaged or loose. Re- place the wire if it is damaged. Heavy-Duty Trucks Maintenance Manual, January 1997 83/1