Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

General Information 00 M1 Maintenance Interval Operations Table: 00-07 The M1 Maintenance Interval Operations table lists all maintenance operations that are to be performed at the M1 maintenance interval. Maintenance opera- tion numbers are reference numbers used to help you find detailed instructions in this manual on the maintenance operations to be performed. IMPORTANT: After performing all operations listed in this table, perform all daily, weekly, and monthly maintenance operations listed in the "Pretrip and Post-Trip Inspections and Maintenance" chapter of the vehicle driver’s manual.

M1 Maintenance Interval Operations for Service Schedules I, II, and III Maintenance Operation Number Operation Description Check M1 Maintenance Interval Operations for Service Schedules I, II, and III 00–04 Lubrication and Fluid Level Check (includes the following) Clutch Release Bearing Lubricating Clutch Release Cross-Shaft Lubricating Clutch Linkage Components Lubricating Shift Control Telescoping Tubes Lubricating and Inspecting, FLA/FLB Shift Control Latch Lubricating and Cylinder Inspecting, FLA/FLB Selection Lever and Pivot Rod Ball Stud Lubricating, FLA/FLB Transmission Oil Level Checking and Breather Checking Fifth Wheel Lubricating Trailer Electrical Connector Lubricating Suspension Lubricating, Front and Rear Knuckle Pin Lubricating Tie-Rod End Inspecting and Lubricating Axle Breather and Lubricant Level Checking Driveline Lubricating Manual/Automatic Slack Adjuster Lubricating and Checking (All Models) Steering Driveline Lubricating Ross Manual Steering Gear Lubricant Checking, Model 503 Drag Link and Power Steering Cylinder Lubricating Power Steering Reservoir Fluid Level Checking Ross Power Steering Gear Lubricating, TAS Series Sheppard Power Steering Gear Bearing Cap Lubricating Cab-Tilt System Checking, FLA/FLB Door Seal, Door Latch, and Door Hinge Lubricating 13–01 Bendix Air Compressor Inspecting 31–01 Fifth Wheel Inspecting 32–01 Suspension Inspecting 41–01 Driveline Inspecting 42–01 Brake Adjusting—Cam Brakes With Manual Slack Adjusters Heavy-Duty Trucks Maintenance Manual, October 2009 00/13