Alternators and Starters 15 15–01 Alternator, Battery, and Starter Checking with a wire brush. See Group 54 of the Heavy- Duty Trucks Service Manual for troubleshooting, adjustment, repair, or replacement instructions. WARNING 7.1 Clean and tighten the battery ground cable, terminal, and clamps. 7.2 Inspect the retainer assembly (or battery hold-downs) and the battery box. Replace worn or damaged parts. Remove any cor- rosion with a wire brush, and wash with a weak solution of baking soda and water. Rinse with clean water, and dry. Paint the retainer assembly, if needed to prevent rusting. Batteries generate explosive gas as a by-product of their chemical process.
Do not smoke when working around batteries. Put out all flames and remove any source of sparks or intense heat in the vicinity of the battery compartment. Make sure the battery compartment has been completely vented before disconnecting or connecting the battery cables. Battery acid is extremely harmful if splashed in the eyes or on the skin. Always wear a face shield and protective clothing when working around batteries. 7.3 Check that there are no foreign objects, such as stones, bolts, and nuts in the bat- tery box. 7.4 After cleaning, connect the cables to the batteries, and tighten them to the torque specifications listed on the battery, gener- ally 10 to 15 lbf·ft (14 to 20 N·m). 1.
Check the tightness of the alternator bracket fas- teners; tighten the fasteners as needed. For torque values, see Group 15 of the Heavy-Duty Trucks Service Manual. 7.5 Coat the battery terminals with dielectric grease. 2. Check the belt tension of the alternator drive belt. Use a tension gauge at the belt’s widest span, and adjust the belt tension if needed. See Group 01 for belt tension specifications. Some engines are equipped with dual alternator belts; check both belts for correct tension. Engines equipped with a serpentine or poly-V belt have automatic belt tensioners and do not require belt tension inspection. 8.
Check the alternator wiring for missing insulation, kinks, and heat damage. Replace or repair as needed. 9. Check the terminals on the battery shut-off switch and the magnetic switch. Make sure the terminal connections are clean and tight. Coat the terminal connections with dielectric red enamel after cleaning. 3. Clean and tighten all charging system electrical connections, including the connections at the starter B terminal and ground terminal, and at the terminators of the alternator charging cable. 4. On the bundled cable that runs from the batteries to the starter, ensure that tie-straps are installed at least every 12 inches (300 mm).
Replace any missing tie-straps and add tie-straps where spac- ing between straps exceeds 12 inches (300 mm). 5. Ensure that all cables have sufficient slack to allow for engine movement, and that there is no pressure on any wiring connectors. 6. Check all wiring inside of damaged convoluted tubing and replace any damaged or missing con- voluted tubing. 7. Inspect the battery cables for wear, and replace as needed. Clean the cable connector terminals Heavy-Duty Trucks Maintenance Manual, October 2009 15/1