Transmission 26 Fig. 7 . Check more often if the vehicle operates under very dusty conditions. CAUTION Operating a Fuller or Spicer transmission with the oil level higher or lower than recommended can result in transmission damage. Do not overfill the transmission. On Fuller transmissions, overfilling will force oil out of the case through the main shaft openings. On Spicer transmissions, overfill- ing usually causes oil breakdown, due to exces- sive heat and aeration from the churning action of the gears. Early breakdown of the oil causes heavy varnish and sludge deposits that plug oil ports and build up on splines and bearings.
Oil overflow may also drain onto the clutch or clutch brake, causing additional problems. 7. For a transmission equipped with an oil pump or an oil cooler, operate the engine for five minutes after filling the transmission, then check the oil level again. f260007a 05/27/93 Fig. 7, Transmission Breather (Fuller shown) 8. Install the fill plug, then tighten it 50 lbf·ft (68 N·m). NOTE: For a Fuller transmission equipped with an oil filter(s), change the filter as instructed under "Fuller Transmission Oil Filter Element Changing", before filling the transmission with oil. 9. Operate the vehicle to check for correct operation. IMPORTANT:
Do not mix types and brands of oil, because of possible incompatibility. Do not use oil additives, friction modifiers, extreme- pressure gear oils, or multiviscosity lubricants. Do not use extreme-pressure additives, such as those found in multipurpose or rear-axle-type lubricants. These additives are not required, and may create transmission problems. Multipurpose oils have relatively poor oxidation stability, a high rate of sludge formation, and a greater ten- dency to react on or corrode steel and bronze parts. f260006a 05/27/93 A B A. Full B. Low Fig. 8, Checking Transmission Oil Level Transmission Lubricant Capacities Transmission Make and Model Capacity: pt (L) NOTE:
The correct oil capacity is established by the fill opening. HD4060/4560 w/shallow sump 80 (38) ALLISON 6. Add oil until it is level with the lower edge of the fill opening. If the transmission has two fill open- ings, add oil to the level of both openings. See Fig. 8 . See Table 1 for transmission lubricant capacities, and see Table 2 for approved trans- mission lubricants. HD4060/4560 w/standard sump 96 (45) FULLER AUXILIARY AT–1202 11 (5.2) FULLER 7-SPEED T–8607A/B 36 (17.0) T–11607A 30 (14.2) Heavy-Duty Trucks Maintenance Manual, November 2001 26/5