. OPERATION DETAILED CONTROLS AND GAUGES position (A). 2. Tighten bolt(1). AUXILIARY ELECTRIC POWER from the 3 - 72 Antenna Before transp orting the machine put ting it inside a building, stored the antenna to prevent an Stow the ante nna as follows . Loosen a Use Radio with Care To ensure safety, always keep th e sound to a level where it is possible to hear outside sou nds during operation If water ge ts into the speaker cas e or radio, it may lead t o an unexpected failure, so be ca reful not to get water on the equ ipment. Do not wip e the scales or buttons with solven t suc h as b enzene or thinner. Wipe with a dr y soft cloth.
If the dir cannot be removed easily , soak t he cloth with alcohol. buttons are all cleared, so set them again. When the battery is replaced, the settings for the p reset buttons are all cleared, so set the 24V Power Source NOTICE Do not use this as the power supply for 12V equipmen It will cause fai lure of the equipment. Pull out the c rear side of th Maximum us able electric power is 8 5 W (24 V x 3.5 A 12V Power (If equipped) This power so urce can be used up to a capacity o f 60W (12V