. OPERATION DETAILED CONTROLS AND GAUGES CIRCUIT BREAKER NOTICE When resetting the circuit breaker, always turn the starting switch OFF first. If the starting switch does not work, even when the starting 3 - 74 switch is turned on grease pump box l perform inspection. , open the circuit breaker box inside the ocated at the front right of machine, and t is generated, the circuit breaker cuts off side the If an excess curren electrical current to from damage. To re after it has been cut If the electric circu remains in. If the res it is pushed in, it is n protect electrical components a nd wiring turn the circuit electrical current t off, push in the reset button.
it is working normally, the rese o normal t button et button pops out again immedia tely after ecessary to check the electric circ uit. REMARK The circuit breaker is a circuit protection device installed to circuits where larg components and wi current in the same restoring the locati replace the breaker e current flows. It protects the ring from damage caused by an a electrical bnormal way as a normal fuse. After repa iring and on of the abnormality, there is no need to . It can be used again. r does not work even when the starting If the starting moto switch is turned to th off the circuit, so ch e ON position, breaker (6) has pro bably cut eck and restore circuit breaker (6) .
If the electrical equi pment does not work even when th e fuse is replaced, breaker ( check and restore c 1) or (9) has probably cut off the circuit, so ircuit breaker (1) or (9). Fuse No. Capacity Circuit Name 1 40A Fuse 1 to 15 Wor 2 20A Righ k equipment headlamp t side headlamp 3 20A Pow er supply grease pump 4 20A Pum p controller (VIS) 5 20A Cab upper headlamp Start 6 20A Pum ing switch p controller (VB) 7 30A Engi ne controller (Power supply) 8 20A Mon itor,buzzer 9 20A Fuse 16 to 20