Komatsu — BEFORE STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS Checks Before Starting Check Coolant Level, Add Coolant WARNING side of the machine, and check top cover (3) and add coolant empty, there is probably water the level of the water in the Supercoolant (AF-NAC) of the same in the radiator, then add 3 - 80 8. Check for problem in gauges Check for problem in the gau ges and monitor in the operator's cab. If any problem is fou nd, replace the parts. Clean off any dirt from the su 9. Clean, check rear view mirro Check that there is no damag e to the rear view mirror. If it is damaged r epair. Clean the sur face of the mirror and adjust the angle so that the a rea at the rear can be seen from the op 10.

Seat belt and mounting clam Check for damage or wear to the seat belt and mounting clamps. If the re is any damage, re place with new parts. Always check the items in this se ction before starting the engine each da Do not open the radiator cap unles s necessary. When checking the coolant, alw ays wait for the engine to cool down and check the sub-tank. Immediately after the engine is sto pped, the coolant is at a high temperature an d the radiator is under high internal pressure. If the cap is removed to check the coolant level in this condition, there is a ha zard of burns. Wait fo r the temperature to go down, then turn the cap slowly to release the pressure and remove it carefully. 1.

Open rear cover (1) at left coolant level is between the (2). If the level is low, open through filler (4) of sub tank t 2. After adding coolant, tighten 3. If the sub-tank (2) becomes leakage. After checking, repa n o abnormality is found, che radiator. If it is low, add Sup density as the Supercool Supercoolant to the sub-tank