Komatsu — BEFORE STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS Check Oil Level in Hydraulic Tank, Add Oil WARNING may cause burns. Wait for the 5. If the level is below the L mark, add oil through oil filler (F) at the top of the hydraulic tank. 3 - 85 temperature to go do wn before starting the work. When removing the o il filler cap, turn it slowly to rele ase the internal pressure, then remove i 1. Set the work equi pment in the posture shown in the diagram on eck the oil level and add oil if 2. If the machine is not in the condition shown in the diagram on engine, run the engine at lo w speed, retract ket cylinder fully, lower the boom, put the ntact with the ground, then s top the engine. 3.

Within 15 secon ds after stopping the engin e, move each control lever (for in all directions to work equipment and travel) t o the full stroke release the internal pressur e. 4. Open cover (1) on the left side of the machine and check sight gauge (G). The o il level should be between the H and L marks. REMARK The oil level will vary depending upon the oil temp Accordingly, use the following as a guide: Before starting op eration: Between H and L lev (Oil temperature 1 0 to 30°C (50 to 86°F)) Around H level 0 to 80°C (122 to 176°F)) Normal operation: (Oil temperature 5