. OPERATION MACHINE OPERATIONS AND CONTROLS Rearview Mirrors WARNING 3 - 93 Be sure to adjust the mirrors before s tarting work. If th ey are not adjusted properly, you cannot secur e the visibility and may be injured or may inj ure someone seriou Loose n nut (1), screw (2), and b olt (3) installin g the mirro r, then adjust the positi on to give the bes t view from the operator' s seat. Adjust the m irror mount so that it is possible t o see any person (or object of height 1 m ( 3 ft 3 in) and diamet er 30 cm ( 11.8 in) at t he rear le ft and right of the machine. nting position and dimensions Install the m irror to the mou nting position dimensions shown.
The values given below are reference values for the w. the range of vie Mounting positi on X1: 220mm (8. 7 in) in) 9 in) mm (6 ft 7 in ) mm (12 ft 2 in) m (10 ft 2 in) X2: 75mm (3.0 X3: 100mm (3. Range of view Y (right side): 2000 mm (6 ft 7 in ) Range of view Z (left side): 3700 mm (12 ft 2 in) m (10 ft 2 in) Range of view H (height): 3100m Mirror A: Must b e possible to see hatched portio n (A) Mirror B: Must b e possible to see hatched portio n (B) Mirror C: Must be possible to see hatched portio n (C)