. OPERATION MACHINE OPERATIONS AND CONTROLS TRAVELING ON SLOPES WARNING Turning or operating the work equipment when working on slopes may cause the machine to lose it balance and turn over, so avoid such 3 - 128 operations. Itis particularly dang If such operations h erous to swing downhill when the bucket is loaded. ave to be performed, pile soil to make a platform (A) on the slope so the machine is kept horizontal during operation. Do not work on a sl ope covered with the steel plates. Even with s light slopes there is a haz ard that the machine may Do not travel up or machine may turn o When traveling, rais ground. Do not travel downh Never turn on slope Always go down to ill in reverse.
s or travel across slopes. a flat place to perform these operations. It may be longer, but it will en sure safety. Always operate or tr avel in such a way that it is possible to s top s afely at any time if the ma chine slips or becomes un stable. When traveling uphil l, if the shoes slip or it is im possible to tr avel u phill using only the force of the tracks, do not use the pulling force of the arm to help the machine travel uphill. There is dang er that the machine may tur n over. 1. When traveling d own steep hills, use the travel lever and fuel c e l ontrol lever to k eep the travel speed low .
an 15°, set the work When traveling down slopes of more th work quipment in the posture shown in the fi gure on the r ight, and ower the engine speed. 2. When traveling u p a steep hill of more t han 15°, set the work e quipment to the posture shown in the d iagram on th e rig ht.