. OPERATION TRANSPORTATION LIFTING MACHINE WARNING 3 - 138 The ope rator carrying out the lift ing operation using a crane mus t be a properl y qualified cr ane operator. Never r aise the machine with an Always make sure that the wire r ope is of ample stren gth for the weight of this When li fting, keep the machine h When c arrying out lifting operatio ns, set the lock lever to the L OCK position to pr event t he ma chine from mo ving unexpectedly. Never e nter the area under or aro und a raised machin e. Never try t o lift the machine in any p osture other than the posture given in the procedure below or using lifti ng equipment other than in the procedure below. may lose its balance.
There is a hazard that the machine may lose its balance. NOTICE d of lifting applies to the standard specification machine. d of lifting differs according to the attachments and options installed. This metho d of lifting applies to the standard specificati on machine The metho d of lifting differs accord ing to the attachment s and options For details of the procedure for mac hines that are not th e standard specification, please consu lt your Koma tsu distributor For weigh t, see "SPECIFICATI ONS (PAGE 5-2)". When lifti ng the machine, carry out the operation o n flat ground as follow 1. Lifting machine Fit wi to the (1). Lif (a): P (b): H (c):
2 re rope (cable) to liftin racke t installed mounting hole of the counterweight and boom foot pin ting weight: 26.5 tons in diameter at lifting position ∅140 mm (5.5in) ole diameter at lifting position ∅75 mm (3.0in) 782mm (9ft 2in) mark for the center of gravity installed to the machine in in diameter at lifting po sition ∅140 mm (5 ole diameter at lifting position ∅75 mm (3 782mm (9ft 2in) mark for the center of 2. The shows the position of the center of gravity in the condition shown in the diagram on the right. s the position of the condition n in the diagram on th (d): Di stance between cente 45 07mm (4ft 9in)