. MAINTENANCE MAINTENANCE PROCEDURE other hydraulic equipment, remove the dirt from inside the line filter as follows. Before removing the line the hydraulic circuit. For details, see "METHOD OF side face of the ± 1.85 4 - 36 CLEAN LINE FILTER, REMOVE DIRT If there is other lter, elease the insid IN HYDRAULIC CIRCUIT (PAG RELEASI NG PRE 1. Remo ve plug ( 2. Using a bolt (1 0 mm (0 .4 in)) , remove f ilter ( 3. Wash filter (1). Be careful t er when washing 4. 5. Replace backu Assemble filter p ring (3 (1) after ) and O-rings washing it. htening m, 133.8 torque fo ± 13.4 lb After assembli ng the lin e filter again, bleed th e air. For d etails, see " BLEEDIN FROM PAGE 4-38)"