. MAINTENANCE MAINTENANCE PROCEDURE EVERY 10 HOURS MAINTENANCE LUBRICATING REMARK The number of arm cylinder foot pins to be greased differs depending on the kind of work equipment. REMARK be greased differs 4 - 42 1. Set to the greasing posture below, lower the work equipment to the ground, then stop 2. Using a grease pum p, pump in grease through the grease fittings 3.
After greasing, wipe off any old grease that was pushed (1) Boom cylinder foot p in (2 places (2) Boom foot pin (2 pla ces) (3) Boom cylinder rod e nd pin (2 places) (4) (5) Arm cylinder foot pin Arm cylinder foot pin (6) Boom-Arm coupling pin (1 place (7) Bucke t cylinder foot pin (1 place (8) Arm c ylinder rod pin (9) Arm c ylinder rod pin ( PC800SE,PC850,PC The to dependin g on the kind o f work equipment. (10 ) Arm-Link coupling p in (1 place) (11 ) Arm-Bucket couplin g pin (1 place)