Komatsu — EVERY 1000 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE REPLACE HYDRAULIC OIL FILTER ELEMENT WARNING stopped, and may cause burns. Wait for the 4 - 65 temperature to go down befo When removing the oil filler c ap, turn it slowly to release the int ernal pressure, t 1. Set the work equipmen t on the hard and flat ground in the maintenanceposture as shown in the figure, then lower it to the ground and stop the eng ine. 2. Remove the cap from oil filler (F) on top of the hydraulic tank, and release the internal pressure. 3. Loosen 4 bolts, then rem When doing this, the cov ove cover (1). er may fly out under the force of spring (2), hold the cover down when removing the bolts.

), valve (3) and strainer (5), take out cles or foreign material inside strainer 4. After removing spring (2 element (4). If there are metal parti atsu distributor. in flushing oil. 5. Clean the removed parts 6. Install the new element i n the place where old element ( 4) was installed. 7. Set valve (3), strainer (5) and spring (2) on top of the ele ment. 8. Set cover (1) in position, push it down by hand, and inst all the cover with the mounting bolts. port (F). e engine according to "Engine Warm 9. Install the cap of oil filler 10. To bleed the air, start th Warm Up (PAGE 3-102)" and minutes. Stop the engine. run the engine at low idle for 10 11.

REMARK Operate the machine after h alting for more than 5 minutes t o eliminate bu bbles in the oi l inside the 12. Check for oil leakage an