Komatsu — HANDLING COUNTERWEIGHT REMOVER

. ATTACHMENTS AND OPTIONS ATTACHMENT GUIDE ATTACHMENTS AND OPTIONS ATTACHMENT GUIDE 6 - 16 8. Operate counter weight removal / installatio n B control lever (12) slowly to the RAISE (f) position and exten d B remover link cylinder (13) to th e stroke end (max.). Then B remover link (14) begins to rise as it is stretched. In this process , raise B remover link (14) slowly b instead of at the speed. y keeping B control lever (12) at its half stroke full stroke to control the remover link rising 9. Operate counter weight removal / installatio n A control lever (15) slowly to the LOWER (f) position, allowin g A remover link (16) to be stretch ed.

In this process, lower A remover link (16) slowly by keepin g A control lever (15) at its h alf stroke instead of at the full stro ke to control the remover link lowering speed. 10. Position the mac hine and the counterweight t o face each other squarely, and the n stretch A remover link (16) until the pin hole of B remover link (14) and the pin hole of the c ounterweight are on the same lev el. chine back and forth until the pin hole of B 11. Operate the ma remover link (14 B ) and the pin hole of the c ounterweight are aligned. This can be done through a fine con trol of B remover link (14).

When doing t his, be careful not to let the c ounterweight fall llow any other person near th e machine when he operation. re aligned, insert 2 pins (18) and install 2 pin ). weight removal / installation A control lever 12. After both pins a stopper bolts (17 13. Operate counter (15) slowly to the RAISE (e) position , allowing the counterweightto (13) at the full str rise. At that time, keep B rem oke (max.), and raise the co over link cylinder unterweight until 14. the backside of Operate counter A remover link (16) is upright weight removal / installatio the LOWER (e) positio settle in the seat. In this pr .

n B control lever (12) slowly to n, allowing the ocess, lower the counterweight to counterweight sl owly by keeping B control lev er (12) at its half stroke instead of at the full stroke to control th e lowering speed and make sure th at the counterweight settles in the seat safely and neatly. REMARK In case the mountin g holes of the counterweight and revolving frame are misaligned, try t o align them proper ly by operating A remover link cylinder (19) and B rem over link cylinder (13).