. LOADING SHOVEL MAINTENANCE MAINTENANCE CHECK BEFORE STARTING Check Oil Level in Hydraulic Tank, Add Oil WARNING may cause burns. Wait for the 5. If level is below the L mark, add oil through filler (F) at top of the 7 - 16 temperature to go down before starting the work. When removing the oil filler cap, turn it slowly to release the internal pressure, then remov 1. Set the work equipm ent in the posture shown in th e diagram on the right, then chec k the oil level and add oil if ne cessary. hown in the ngine at low 2.
If the work equipm diagram on the righ speed, retract the lower the boom, set and stop the engine ent is not in the condition s t, start the engine, run the e arm and bucket cylinder rod s fully, then the bucket teeth in contact wit h the ground, . after stopping the engine, move each 3. Within 15 seconds control lever (for wo in all directions to re rk equipment and travel) to t he full stroke lease the internal pressure. 4. Open cover (1) on t he left side of the machine and check sight gauge (G). The oil l evel should be between the H and L marks. hydraulic tank. REMARK pending upon the oil temperature. lowing as a guide: ation:
Between H and L levels to 30°C (50 to 86°F)) round H level to 80°C (122 to 176°F)) The oil level will vary de pending upon the oil tempera Accordingly, use the fol Before starting oper ation: Between H and L levels (Oil temperature 10 Normal operation: A (Oil temperature 50