. LOADING SHOVEL MAINTENANCE LOADING SHOVEL MAINTENANCE 7 - 20 4. Remove th e cap from oil filler (F) on top of the hydrauli c tank. 5. Place a co ntainer to receive draine d oil under the dra hine. Remove dra sen (P2) to drain o in plug in plug il. After located in (P1) on the the underpart of the mac suction tube and then loo draining oil the hydrau from drain plug (P1), remove drain plug (3) under lic tank and drain plug (P4) on the suction tube to ining oil. O-rings fitted to drain plugs (P3) and (P4) for any drain rema 6. Check the damage. If After draini Tighteni (P1) an 18.1 lbf (P3) and When re on yours damage. If any, replace the defecti ve O-ring with a ne w one.
After draini ng oil, tighten drain plugs (P1), (P2), (P3) an d (P4). Tighteni ng torque (P4): 68.6 ± 9.8 Nm (7 ± 1 kgm, 50.6 ± 7.2 lbft) When re moving drain plug (P3), (P 4), be careful not to get oil elf. 7. Add the sp ecified amount of new an d clean oil through oil filler port (F). Ch eck that the oil level is be tween H and L on th e sight gauge. For details of o il level check, see "Chec k Oil Level in Hydraulic Tank, Add Oil (PAGE 3-85)". 8. 8. Bleed the air from the circuit after cl eaning or replacing the filter element or strain er, or after changing the oil. For details of the method of bleeding the air, see "BLEEDING AIR FROM HYDRAU LIC SYSTEM (PAGE 4-38)"