. OPERATION DETAILED CONTROLS AND GAUGES Travel Levers (with Pedals and Auto-deceleration Device) WARNING This lever (2) is used to change the direction of travel between forward and reverse. ( ) shows the pedal operation. (a) FORWARD: The lever is pushed forward (The pedal is angled forward) (b) REVERSE: The lever is pulled back (The pedal is angled back) N (Neutral): The machine stops Work Equipment Control Lever Left work equipment control lever (3) is used to operate the arm and upper structure. Arm operation (a) Arm OUT (b) Arm IN Swing operation (c) Swing to right (d) Swing to left 3 - 42 Do not rest your foot o n the pedal during operations.
If the ped al is depressed by mistake, serious accident. Be e travel or steering operat rest your foot on it. the machine may suddenly mov e an d cau se a xtremely careful when operating the peda l for ions. When you are not using the pedal, do not If the track frame is facin g the rear, the direction of travel o perations will be reversed when the tr forward when operated forward; the left and rig avel lever is operated. (The machine will tr avel in reverse, and in reverse w hen operated ht directions will also be reverse When operating the trav el levers, check if the track fram e is f acing the front or the rear.
(If the the front.) sprocket is at the rear, the track f rame is fa cing REMARK If the lever is shifted to t he FORWARD or REVERSE position from the Neutral position, the a larm sounds to warn that the machine is start ing to move. N (Neutral) : The upper structure and arm are held in position and do not mov e.