126 Maintenance Section Hydraulic Tank Breaker Relief Valve - Clean i01562008 Hydraulic Tank Breaker Relief Valve - Clean i01556950 Lift Arm and Cylinder Linkage - Lubricate SMCS Code: 5118-070 SMCS Code: 5102-086-BD; 6107-086-BD g00809393 Illustration 208 Lubricate two fittings on each lift arm. Lubricate the fitting on the cylinder linkage knuckles of each side of the machine. g00811305 Illustration 207 Note: There is a total of six fittings. The hydraulic tank breaker relief valve is located on the top of the hydraulic tank on the right side of the machine. i01562023 Logging Fork Clamp - Lubricate 1.
Press the button on the top of the hydraulic breaker in order to relieve the pressure in the hydraulic tank. Remove the hydraulic tank breaker relief valve. SMCS Code: 6113-086-BD; 6410-086-BD Wipe off all fittings before any lubricant is applied. 2. Clean the hydraulic tank breaker relief valve in a clean, nonflammable solvent. Shake the breaker relief valve dry or use pressure air to dry the breaker relief valve. 3. Install the hydraulic tank breaker relief valve. g00811307 Illustration 209 Apply lubricant through three fittings on each side of the logging fork. There is a total of six fittings.