132 Maintenance Section Transmission Oil Filter - Replace i01562428 Transmission Oil Filter - Replace SMCS Code: 3067-510 NOTICE Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, test- ing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before open- ing any compartment or disassembling any compo- nent containing fluids. Refer to Special Publication, NENG2500, “Caterpillar Tools and Shop Products Guide” for tools and supplies suitable to collect and contain fluids on Caterpillar products. g00101318 Illustration 223 4.
Apply a thin coat of clean transmission oil to the gasket of the new filter element. Install the new filter element by hand. When the gasket contacts the filter mounting base, tighten the transmission oil filter by an additional 3/4 turn. Dispose of all fluids according to local regulations and mandates. 5. Start the engine. Slowly operate the transmission controls in order to circulate the transmission oil. 1. Park the machine on a hard, level surface. Lower the bucket to the ground with a slight downward pressure. Engage the parking brake and stop the engine. 6. Move the transmission control to the NEUTRAL position. Inspect the transmission oil filter for leaks. 7.
Check the transmission oil level. Reference: Refer to Operation and Maintenance Manual, “Transmission Oil Level - Check” for the correct procedure. i01556432 Transmission Oil Level - Check SMCS Code: 3030-535-FLV g00811546 Illustration 222 2. The transmission oil filter is located on the left side of the machine near the articulation joint. Use a strap type wrench to remove the transmission oil filter. Dispose of the used oil filter properly. 3. Clean the filter mounting base. Remove all of the used filter gasket from the filter mounting base. g00809008 Illustration 224 The dipstick for the transmission oil level is located on the left side of the machine near the articulation joint.