Komatsu — OPERATIONS AND CHECKS AFTER STARTING ENGINE

. OPERATION OPERATION any problem is found, contact your Komatsu distributor. 3 - 112 To warm up the hydraulic o il in cold areas, do as follow 2. After completing the w arming-up operation, chec the engine rotation is smoo th, then check that the work equipment control lever is at the H OLD position and set work equipment lock lever to the FREE Operate the bucket con it to the HOLD position trol lever to the TILT position repeatedly to warm up the hy and return draulic oil. Relieve the circuit at th sec. This brings the oil to th warm up the oil. After carrying out the of 10 4.

gauges and caution lam If there is any abnorma lity, carry out maintenance o r repair Run the engine und er a light load until eng ine water temperature gauge (2) mperature gauge (3) are in the gre Check for abnormal ex REMARK The rotating speed of the c abnormality. ooling fan differs according to the following conditions, but this does not indicate any The cooling fan speed incr eases when the hydraulic oil temperature, engine coolant te mperature, or transmission oil t emperature are high. fan is rotating in reverse, it rotates at a fixed speed proportional to the engine speed, lant temperature.

However, when the cooling regardless of any oil or coo rotates at a tional to the engin e speed,