. OPERATION OPERATION If the braking capacity limit is exceeded, a forced cooling system for the brakes is needed, so please consult your Komatsu distributor. 3 - 135 PRECAUTIONS WHEN DRIVING MA CHINE When the machi ne travels at high sp eed for a long dist ance, the tire s become extremely hot. This causes early w ear of the tires and s hould be avoided a s much as possib le. If the machine must be d riven for a long distance, take the following precau tions. gulations related to this machine, and drive carefully. the machine, carry out the checks before starting.
Follow the re gulations related to this machine, and drive carefu Before driving the machine, carry out the checks b efore starting The most suit able tire pressure, travel speed, or ti re type d iffer according to th e conditio n of t he t ravel surface. Contact your Komatsu distributor or tire dealer for information. The following is a guide to suitab le tire pressures and speeds w hen traveling o n a p ave d surface with standard tires. (23.5-2 5-20PR) 0.39 MPa (4.0 kg/cm2, 56.8 PSI) .31 MPa (3.2 kg/cm2, 45.4 PSI) /h (8.7 MPH) pressure before starting, when the tire is cool. Tire pressure Front wheel: 0.39 MPa (4.0 kg/c Rear wheel:
0 .31 MPa (3.2 kg/cm Speed:14 km /h (8.7 MPH) Check the tire pressure before st arting, when the t After traveling for one hour, stop t he machine for 30 minutes and check the tires and all pa rts fo r an y abnormality. Check the oil level and coolant le vel also. xtremely cold areas, do as follows. When stoppin g the machine in e xtremely cold are as, do as follows. To prevent th e radiator water tem perature from risi ng suddenly, do not suddenl y stop the engine.
Gradually cool the radiator w ater down before st opping the engin Always travel with the bucket em Never put "ca lcium chloride" or " dry ballast" in the tires when tr aveling PRECAUTIONS REGARDING BRAKE FUNCTI ON When traveling l ong distances conti nuously downhill, the frequenc y of using the brake may increas e. As a result, depending on t he weight of the m achine and the grade of the slope, the machine's braking capacity may be heat. of the values for this machine. the machine' aking capacity exceeded and t he brakes may over The table below shows a guideline of the values for t his machine.
Machine weight (t) Slope grade Aver (%) limi Braking capacity limit age travel speed t (km/h (MPH)) Downhill distance limit (continuous) (km) 22 - 24 (unloaded) 10 40 (24.9) 2 20 17 (10.6) 1.2 28.5 - 30.5 (loaded) 10 30 (18.6) 1.8 20 12 (7.5) 0.6