. OPERATION TRANSPORTATION HOLD operator's NOTICE 3 - 148 The machine can be lifted only if it has ho ok mark l abels. When lifting the m achine, stop the machin e on leve l ground and do as 1. Start the eng ine, make sure tha t the machine is then set the w For details, s (A): 40 - 50 c ork equipment t o the tra vel posture. ee "MOVING TH E MACHINE (PAGE 3-11 m (16 - 20 in) 2. Check that th e work equipme nt c ontr ol lever is at the H position, then position (L). set the work equipment lock leve r to 3. Stop the eng ine, check that t he area around the compartment the front fram is safe, then lock e and rear frame with th do not e frame l articulate 4.
Use wire rope s and slings that match t he weigh t of the machin e, and wind the wire rope a nd fix it to the lifting points as sho wn in the figure. Use protectors, e tc. so that the wire ropes wi ll not be b roken at s harp ed ges Use threaders an d bars having sufficient wid th so that the slings and wi re ropes will not touch the ma For machines eq uipped with a rear full fende r, remove the rear fu ll fend er before carrying out the oper 5. After setting t he wire ropes, lift up the m achine a nd stop at 100 to 200 mm (3.9 to 7.9 in) ab ove the ground, and check that th e wire ropes are not slack and the machine is leve l, then lift up slowly.