. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE If the oil level does not reach the lower line, add oil through filler port (F). REMARK For axles with ASD (Limited-Slip Differential), the brand of 5. If the oil level is above the upper line, drain off the excess oil lbft) CLEAN AXLE CASE BREATHER WARNING 4 - 28 3. Set the o il level gauge (G) as shown in the right diagram. 4. The oil le vel is correct when it is betwe en the two lines provided l level gauge. lubricating oi l is different. Use the specifi drain plug (P) and check the 6. If the oil level is correct, install plug ( ng torque:
127 to 177 Nm (13 to 18 kgm, 94.0 to 1 30.2 When cleanin g the axle breather, apply the pa rking brake and secure the front and rear frames with Remove all mud and dirt from around th e breather with a brus After removi ng the mud or dirt from arou the breather , immerse it in cleaning fluid When clean (front and re After removi ng the breather, take steps t o prevent dirt or dust f rom entering the