Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE TURN, REPLACE BOLT-ON CUTTING EDGE WARNING lever securely to the LOCK REPLACE BUCKET TEETH (If equipped) 4 - 34 It is dangerous if the work equipme nt moves by mistake during the turning o r replacement operation Set the work equipment in a stable condition, stop the engine, then set the work equipment lock l position. Turn or replace the cutting edge before the wear reaches the edge o 1. Raise the bucket to a suitabl the bucket to prevent the bu Raise the bucket so that th horizontal. 2. Remove nuts and bolts (1), 3. Clean the mounting surface 4. Turn cutting edge (2) and in the edge, install it to the opp right edge to left side).

If both sides of the cutting e part. If the wear extends to th mounting surface before ins 5. Tighten nuts and bolts (1) u Tightening torque for mount 6. Tighten the mounting bolts a niformly so that there is no gap between the bucket and c ing bolt: 745 ± 108 Nm (76 ± 11 kgm gain after operating for several hour ONE-PIECE TOOTH , replace them as follows. e height, then put blocks (A) under cket from coming down. e bottom surface of the bucket is (1) and (2), then remove bucket e of bucket tooth (3). et. ms so that there is no clearance op surface of the bucket.

t becomes impossible to add a 0.5 orn, correct the mounting surface rming between the teeth and tip of the bucket, tighten bolts and nuts (1) and (2) f the teeth with a hammer. ng bolt (1): 863 ± 941 Nm (88 ± 96 kgm, 636.5 ± 694.4 lbft) (2): 588 ± 647 Nm (60 ± 66 kgm, 434 ± 477.4 lbft) for a few hours, tighten the mounting bolts again. When the bucket teeth are worn 1. Raise the bucket to a suitabl the bucket to prevent the bu Raise the bucket so that th horizontal. 2. Remove the bolt and nuts tooth (3). 3. Clean the installation surfac 4. Install new teeth to the buck When doing this, insert shi between the teeth and the t Continue to add shims until i mm (0.02 in) shim.

If the mounting surface is w before installing the teeth. 5. To prevent any gap from fo temporarily, then hit the tip o Tightening torque of mounti 6. After operating the machine ng bolt (1): 863 ± 941 Nm (88 ± 96 k gm, 636.5 ± 694.4 lbf (2): 588 ± 647 Nm (60 ± 66 k gm, 434 ± 477.4 lbft) for a few hours, tighten the mountin g bolts again.