. MAINTENANCE SERVICE PROCEDURE EVERY 100 HOURS SERVICE LUBRICATE REAR AXLE PIVOT PIN (3 places) 1. Using a grease pump, pump in grease through the grease CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL WARNING may cause burns. Wait 1. Lower the bucket horizontally to the ground and stop the oil level should be between the H and L marks.
NOTICE 4 - 43 Maintenance f or every 50 hours service should be ca rried out rked by the arrow ing, wipe off any old grea se that was pushed o The parts an d oil are at high te mperatur e immediately temperature t o go down before s tarting the When removi ng the oil filler cap, turn it slo wly to release the intern al pressure, then remo for the ait for 5 minutes, then che ck sight gau ge (G). If the oil has bee n added to above H level, stop the engine a nd wait for hydraulic oil to c ool down, then drai n the exce ss oil from the drain plug the oil is above H level, it will damag e the hydr aulic circuit o r cause th to spurt out.
below the L level , open th e inspection cover ab ove the step and ad d oil through oil filler port (F)